Earth Anchors

	Economical Simple Installation Ships UPS Heavy Holding Capacity Proven Results Time saver
Earth Anchor Kit Click for Larger View
IMPORTANT - CONFIRM LOCATION OF ALL UNDERGROUND UTILITIES BEFORE INSTALLATION


Step 1 – Insert a driving rod into the Earth Anchor. Using a heavy hammer, drive the Earth Anchor into the ground until only the cable loop is showing above ground level.	Step 2 – Pull drive rod out, slip rod through loop in pull cable, and then pull cable taut. Keep pulling until there is no additional movement. This positions the Earth Anchor into the“set” position.	Step 3 – The Earth Anchor is “set” for maximum holding capacity when it is perpendicular with the direction of the securing cable. Now loop your guying strap or cable through the cable loop and complete your tie down procedure.

For additional instructions on tree staking click here
For specific instuctions in a printer friendly format click here

		Per	Cable	Cable	Holding	Tree
Model	Item #	Pack	Length	Diameter	Capacity	Size
400	3A-EC400	50	20”	1/16”	300#	1” to 3”
680	3A-EC680	24	30”	1/8”	1100#	Up to 6”
880	3A-EC880	12	42”	3/16”	3000#	Up to 11”
Earth Anchor Kits *
400	3A-EK400	1	12'	1/16”	300#	1” to 3”
680	3A-EK680	1	13'	1/8”	1100#	Up to 6”
880	3A-EK880	1	15'	3/16”	3000#	Up to 11”
Kit consists of : 3 Anchors with attached galvanized steel cable, 3 tree collars, 3 cable clamps (and 3 turnbuckles for the #680 and #880 size) Also available with a stainless steel cable.
Earth Anchor Driving Tool
	3A-ET400	1
	3A-ET680	1
	3A-ET880	1