|
Speed Stakes
|
|
- Cost less than wooden or steel stakes
- Faster installations
- No costly removal
- System eliminates wire, hose, turnbuckles, and
collars.
- For trees up to 6" in caliper
- Wire above ground prevents weed wacker from
cutting strapping
|
|
|
Pound for pound one of
the best, least expensive staking systems available
How the Speed Stake works
|
|
Lock the Speed Stake into the
driving tool. Drive into the soil at an angle, pointing the anchor
shaft where you want to tie off to the tree. Remove tool and slip tool
through anchor eyelet and pull upwards until no movement is felt. Tie
off our Soft Strap guying strapping to the tree, then tie the Soft
Strap to the Speed Stake eyelet shown below. If the tree ball settles,
loosen the Speed Stake knot, take up the slack and retighten the Speed
Stake knot. No turnbuckle, hose or wire to worry
about. Removal is easy. Clip wire below ground level. With pliers, form
the wire over leaving no sharp ends.
|
Click on image to enlarge
|
|
For additional instuctions on tree staking
click here
|
